Water Well Drilling in Zimbabwe

Nov 19, 2026

Leave a message

Water Well Drilling in Zimbabwe

Our deep-well drilling team has been working continuously in Zimbabwe since 2022, and this is one of the community water wells we drilled there. The site sits on weathered rock under a layer of sand and gravel, with no access road and no grid power, so everything is planned around the rig and the compressor that travel with the crew.

Drilling starts with a surface casing to keep the top of the hole open. The overburden is drilled with a mud system that carries cuttings out of the hole and holds the wall in place; once the bit reaches bedrock, the crew switches to a DTH hammer, where the hammer works at the bottom of the hole and the compressor supplies the air. Rods, bits and casing were supplied together with the machine as one package, so nothing had to be sourced locally mid-project.

After completion the well was developed, tested and handed over to the community, and the local operators were trained on daily checks, bit changes and compressor maintenance. To date our deepest hole in the country reached 473 m, and our largest ventilation shaft was drilled at 400 mm diameter.

Send Inquiry